 |
How To Jailbreak iOS 6.0.1 Using Redsn0w 0.9.15b3 (Tethered) Downloads: Redsn0w: Windows - bit.ly Mac - bit.ly iOS 6.0.1 Firmware File: bit.ly Notes: - This is tethered jailbreak. - Works on iOS 6.0.1 and 6.0 This does not work with the iPad 2, iPad 3 or iPhone 4S - This works with the following devices: iPod touch 4G iPhone 3GS/4 (GSM/CDMA) Written Guide: 1. Download Redsn0w from the link above, extract and open it NOTE: If you're on Windows Vista or Windows 7 then you should right click Redsn0w and set compatibility to windows XP (service pack 2) and then run it as the administrator 2. Go to Extras and click Select IPSW. Then select your iOS 6.0 (not 6.0.1) firmware file. 3. Go back and click "Jailbreak" and enter DFU mode by following the below steps or follow the on screen guide in redsn0w: a. Make sure your device is plugged in and turned off then hold down the power button for 3 seconds b. Continue holding the power button and start holding the home button for 10 seconds c. Let go of power and continue holding home button for 15 seconds 4. Select install Cydia and any other options you want except "Install custom bundles". 5. Wait for it to finish and reboot 6. Close out of Redsn0w 7. Open Redsn0w and go to "Extras" 8. Click Select IPSW file again and select the iOS 6.0 (not 6.0.1) firmware file. 9. Click "Just boot" and enter DFU mode again by following the instructions in step 3 10. When you boot up you should have a working tethered jailbreak on 6.0.1 Dev team <b>...</b> |
From:
iPodhacks142
Views:
2
 0
ratings |
| Time: 06:48 | More in Science & Technology |
How To Jailbreak iOS 6.0.1 Using Redsn0w 0.9.15b3 (Tethered)
Subscribe to Applenews247.Com Newsletter
